Identify the WING unit and establish a common datum
A detachable case enquiry needs more than an overall length, width and height. Start by identifying the physical console and its exact configuration; do not substitute measurements from WING Compact or another WING variant. List attached accessories and anything removed for transport. The GOODCASE catalog identifies the WING Detachable Flight Case, but does not establish an order-specific internal layout or mechanism. Treat those details as design questions, not included features.
Choose a reference face and orientation that buyer and supplier can recognise in every photo and drawing. Label front, rear, left and right, and show where each measurement begins and ends. Record feet, projecting controls and connector bodies separately from the main housing. A common datum lets the supplier relate a support position or cable exit to the same physical point instead of combining dimensions taken from different edges.
Measure transport, operation and separation as three different states
Create separate sketches for the packed configuration, the intended operating position and the proposed separation sequence. Measure the screen movement and hand access actually needed by the operator, and identify controls that must remain untouched. Show which parts stay on the console and which belong to the removable case assembly. If the separation method is not yet decided, describe the desired workflow and ask the supplier to propose it.
For any proposed removable assembly, ask the drawing to locate its engagement points, removal direction and the space needed to withdraw it. Mark where hands can reach without crossing controls or cables, where the released part will be supported and where it will be stored. If the design proposes a hinge or assisted movement, review its complete swept path. The site category alone is not evidence that this WING case uses hydraulic assistance.
Assign each clearance to a specific interface
Distinguish the measured console envelope from support, restraint and no-contact zones. Ask for a drawing that keeps proposed foam or hardware away from faders, screens, ports and the ventilation areas identified for the actual unit. Give each clearance a purpose: a moving screen, a hand grip, a plug body or a removable component. Avoid specifying one unexplained allowance around the whole console.
Provide representative plug dimensions, cable exit directions and cable-maker bending guidance where available. State which connections remain attached during operation and which must be removed before separation or closing. Check that the proposed cable route does not cross an engagement point or become trapped during reassembly. A service loop should be reviewed through the entire movement, not only with the case fully open.
Use a repeatable reassembly check before releasing an order
Ask the supplier to explain how the removable assembly returns to its intended position and how engagement is checked. For an agreed sample or mock-up, rehearse removal and reassembly with the actual console configuration and representative cables. Record whether support points align, clearances remain accessible and the proposed closures engage without pressing on controls. Agree handling instructions with the supplier; do not infer a one-person process or stability from the product name.
Send GOODCASE one RFQ pack containing the dated measurements, annotated photos, three-state sketches, accessory list, interface map, quantity and destination. Request a revision-controlled proposal and make unresolved dimensions explicit. Reference the main WING Detachable Flight Case product page for the offer, then confirm included parts, mechanism, materials, commercial terms and any required evidence in the quotation. A change to the console, accessories or detachable interface should trigger a new fit review before a repeat batch.